Fork Setting
Fork Setting on the EVD sequential transaxle is achieved by means of one shim on the Selector Barrel. To determine the thickness for this shim proceed as follows.
1. Assemble all hubs onto the pinion shaft and stand gearbox upright on its front face.
2. Using a vernier and straight edge measure the distance from the rear face of the gearbox to the top of the rearmost hub.
3. Make a note of this height and subtract 2.25mm from it, the resultant number is the shim thickness required. Select the appropriate shim from the range supplied by Elite.
4. Fit this shim to the selector barrel and fit to the bearing carrier, tighten up the selector barrel nut to 50 lbs.ft (67.80 Nm)
5. The selector forks can now be slid over the barrel and located with the fork pin (ERT-IN-020) and circlip (ERT-ST-040)